Diagnostic: Visual inspection, Hot spot. Electrical: Insulation resistance, Wet leakage current Performance: Pmax at STC, Temperature coefficients, NOCT, Pmax at low irradiance. Thermal: Bypass diode test, Hot spot. Irradiance: Outdoor exposure, UV exposure, Light soaking. Environmental: Temperature cycles, Humidity. .
Electrical hazards: Dielectric withstand, Ground continuity, Accessibility, Cut susceptibility, Impulse voltage, Reverse current, Partial discharge. Mechanical hazards: Module. .
This loading test is to investigate the ability of the module to withstand wind, snow, static or ice loads. Mechanical load comes after Damp Heat and. Modules must comply with the international standards: IEC 61215 in the case of crystalline types, or IEC 61646 in the case of thin film types. Modules must also carry a CE mark. [pdf]
[FAQS about Photovoltaic panel standard setting]
Enter your inquiry details, We will reply you in 24 hours.
